E
.
Learndmv
DMV PRACTICE
Toggle navigation
Find your state
Exam types
Practice tests
Sign in
Create account
↗
← Leave quiz
Fort Lauderdale Fire Rescue Driver Engineer Manual Practice Exam
Practice mode
Question
1
of 10
QUESTION 1 / 10
Where is the hydraulic equipment rack located?
Choose one answer below.
A
Upper left of the vehicle body
✓
B
Upper right of the vehicle body
✓
C
Lower back of the vehicle
✓
D
In the cab area of the vehicle
✓
QUESTION 2 / 10
What is the function of the standpipe in fire pumping operations?
Choose one answer below.
A
To increase water pressure
✓
B
To ensure adequate water supply during a fire
✓
C
To store excess water
✓
D
To measure flow rate
✓
QUESTION 3 / 10
What is the difference between pumping to lines level with the pump and lines laid up or down a stairway?
Choose one answer below.
A
There is no difference in pressure needed
✓
B
Additional pressure is needed for increased elevation
✓
C
Reduced pressure is needed for increased elevation
✓
D
Only pressure is needed for ground-level pumping
✓
QUESTION 4 / 10
What is the normal range for the air pressure gauges?
Choose one answer below.
A
80 - 100 psi
✓
B
100 - 120 psi
✓
C
120 - 140 psi
✓
D
140 - 160 psi
✓
QUESTION 5 / 10
What is the maximum speed at which the transmission should be shifted into drive for pumping?
Choose one answer below.
A
10 mph
✓
B
15 mph
✓
C
20 mph
✓
D
25 mph
✓
QUESTION 6 / 10
What is the size of the fuel tank in the fire rescue vehicle?
Choose one answer below.
A
60 gallons
✓
B
65 gallons
✓
C
70 gallons
✓
D
75 gallons
✓
QUESTION 7 / 10
What is the minimum water depth required around the strainer at a drafting site?
Choose one answer below.
A
12 inches
✓
B
18 inches
✓
C
24 inches
✓
D
30 inches
✓
QUESTION 8 / 10
What should be inspected during the pump check?
Choose one answer below.
A
Only the pump’s pressure gauge
✓
B
TPG operation, foam system, primer, pump engagement, leaks, and transfer valve
✓
C
Hydraulic hoses and fittings only
✓
D
Check for manual pump operation only
✓
QUESTION 9 / 10
What are the set pressures for a 1 ¾" 100' Pre-Connect front bumper line?
Choose one answer below.
A
100 psi for 175 GPM
✓
B
75 psi for 175 GPM
✓
C
50 psi for 150 GPM
✓
D
90 psi for 200 GPM
✓
QUESTION 10 / 10
What settings are available for the Jacobs Engine Brake?
Choose one answer below.
A
Low and High only
✓
B
Medium and High only
✓
C
High, medium, and low settings
✓
D
Standard and Performance
✓
← Previous
0 of 10 answered
Next question →
Finish & see results →